Space systems design (spacecraft, satellites, space stations and their equipment)
Amirhossain Adami; zahra pourJabari; Mohammad azhdari; Ali Saadat dar; Hanieh Eshaghnia; Kazem gholipour; seyedmohammad mirmohammadi; Alireza Ahangarani Farahani
Articles in Press, Accepted Manuscript, Available Online from 21 April 2024
Abstract
In this research, the structure of the probes sent to other planets is first investigated and the common structures are introduced. In the following, the system design process of the Armita probe, which was prepared for the first national competition of the probe robot (Iran Space Research Institute), ...
Read More
In this research, the structure of the probes sent to other planets is first investigated and the common structures are introduced. In the following, the system design process of the Armita probe, which was prepared for the first national competition of the probe robot (Iran Space Research Institute), will be discussed. Armita team has won the first place in the first phase of the competition in 1401. The probe design process is based on the ECSS standard and is presented briefly, which includes the compilation and extraction of the requirements document, function-performance tree, product tree and finally the conceptual design of the sub-systems to achieve the intended mission. Based on the extracted results, the Armita probe with a mass of 6.9 kg and geometric dimensions of 48 x 38 x 36 cm with a total energy consumption of 112 amp hours will be able to perform the intended mission and satisfy all technical, dimensional and mass requirements well. shows
Space systems design (spacecraft, satellites, space stations and their equipment)
Amirhossain Adami; Mehran Nosratollahi; Hanieh Eshagh nia; Sajjad Kheirkhah; Shiva Emami; Ali Saadat dar; Narges Afsari; Khashayar Mashhadi; Mansour Hozuri
Volume 13, Issue 2 , June 2020, , Pages 63-77
Abstract
The CANSAT design, a simple and small scale of a satellite, is an experience for preparing for the design of a Life cycle of the space project. In this paper, the process of design and construction of ARTA CanSat, which is participated in the scientific-exploratory class of international competition ...
Read More
The CANSAT design, a simple and small scale of a satellite, is an experience for preparing for the design of a Life cycle of the space project. In this paper, the process of design and construction of ARTA CanSat, which is participated in the scientific-exploratory class of international competition in CANSAT Iran, has been written. The operation scenario is that an automatic scanner system, lands after releasing from 300 meters above ground level with using a recovery subsystem (parachute), which is controlled its downfall and landing position by the parachute controller system. During the descent, the data is transmitted by the sensors and sent to the ground station. After touchdown, the Hotwire system's operates and separates the parachute from the Rover section; Then CanSat with the moving on the ground by using the simpler section embedded underneath the structure, performing excavation while moving to the target point. Throughout the mission, the health of the biological payload is preserved.
